Elevator Forum

I’m getting a 363 door fault. But my door fault list does not go up that high. Does any one know what a 363 is ?

When DCB goes low still have same problem. I’m losing my ready status on door diagnostics. If you reset the PA6 board or the main line you get ready o...

I don’t need lon capability’s to replace L24 cards like the LN board? The L24 for the DCB is in the COP ? Last edited by Jluff; 05/20/22 10:18 AM.

Ok. So if that input ends up being the problem how do I move DCB to a spare ? Right now DOB and DCB on the only ones in that column 8 they are in the ...

And it will stay low until injection is disabled ?

Another note. Door diagnostics shows trip speed at 3. Shouldn’t that be like 30.

I can’t get rid of the dcb high. Pulled wires still high. Door diagnostics screen looks good. DCI parameter is 0. When door is closed says GLRDCLDCL 6...

After you enable injection how do you change dcb to low ?

Txs dirt. I will be Back tomorrow. It’s Harmonic. My door smart fast doesn’t work on my lap top. I don’t know why. I think it’s super old version of I...

Vertical express wants big time $ for a PA6 ...with generic software Installed I think. So I could just use the uit for parameters and not have to dow...

Does anyone have procedures for the UIT to do door scan and other functions ?

I have an mph2 Print If thst helps

Is there a manual for the interface ?

Thanks dirt