Elevator Forum

CAUTION! If for any reason you do need to use a jumper on MR Eng. mode, if at all possible, you should never jump both the cabin and hall door contact...

You're right, Montana. It should only fault out if it's under normal operation. DLM is disabled on all forms of engineer mode. There might be a better...

You might be able to pole it from the floor below, but be careful, don't open the door too far. Don't want a fall down the shaft.

If you can access the inside of the cabin, you should be able to access the Access enable switch on the COP. Once enabled, you should be able to use t...

You should be able to find them at unitec.com under the door operator section. You should be able to find the applicable circuitry even in the Glide A...

You could also consider MCE Motion 2000. It's pretty good.

Don't forget about Vision 2.0. It's the successor to MH3000. Whatever you do, don't settle for any of that PLC stuff. Too much like a relay system and...

Instead of SmartRise, I would suggest this controller. It's very similar to SmartRise, but works better and has better tech support. https://www.alpha...

My suggestion would be the Electrodyn one. This is because their product includes a DOL/DCL magnetic switch kit. The reason I recommend this is becaus...

I would recommend either the GAL MONXT or the Wittur SGV (AMD and LD-16 similar).Both of these door operators are European style, which typically have...

I would recommend either the GAL MONXT or the Wittur SGV (AMD and LD-16 similar), especially if the building is prone to vandalism or heavy use.Both o...

I would recommend either the GAL MONXT or the Wittur SGV (AMD and LD-16 similar).Both of these door operators are European style, which typically have...