Elevator Forum

Crickets.. Thanks y'all. Still looking.

What would a 79 fault be?

Can you email me a copy of the test procedure? [email protected]

Me too actually. Need to know how today if possible.

75 Safety RTS. Basically is saying safe circuit is open after landing doors closed. Doors maybe bouncing back open after its closed. Or your Gate swit...

PUT CONTROLLER ON INSPECTION. THEN RESET. THEN HIT THE RESET AGAIN MID BOOT UP. AND POST BACK IF IT DOES NOT RESET

Figured it out. CPUA board bad. Hall and car nodes good. CWIL good. IOD good. Replaced and reprogrammed CPUA. Motor starter coming in now. Running nor...

94 Error FATL. Only resets by turning lift off while on inspection. Once rebooted, turn off inspection. Should be gone. If it comes back you need to r...

Will it move on temporary run control using jumpers in the controller? Does it have lights on the control board? Does it have a SMIC board?

Thank you so much. At present the elevator is still at the 1st landing. Pi and controller saying it is at floor 2. We are ordering selector magnets an...

Anyone have a fault list pdf they can share with me? Email me at [email protected]

Ok. 2 new faults. 87? And 49? Any ideas? The car runs on inspection only.