Elevator Forum

Your email address?

RealTimeDisplay signals (selectable with 6_75)unitcommentSpeed and position: 1. Speed from motor resolverm/s 4. Position from motor resolverm 7. Dista...

Your mail addresse ?

Hi AbramYour EBD battery is empty

Fault Code 2111 - Missing buttons from floor - Group receives stuck button or offline events for all buttons on some floor.These buttons have been onl...

adjust 50% weight and 0% Menu 5-1What kind of drive are you working on

Adjust 50% weight and 0% load weightWhat kind of drive are you working on?

Still running... i ordered a new scpu

After turning off the power 25 times the cpu started up and the elevator is running right now ,i have a suspicion the scpu card is bad.Thx for the hel...

I will check it 🙂 thanks agian..

Thanks for the answer AlexAll the fuse is good and volts looks fine.. everything that is measured at the safety circuit looks right. I cant entry the ...

Jubril... check menu 3-1 and menu 3-2

Set all the drive parametersChecking the load weighing devicePlace the elevator under the bottom floor before making a shaft setup in rdf, then menu 5...