Elevator Forum

0109= Drive position lost.Drive has lost position Drive count differs more than 300 mm at 30 or B30 vane edgeSynchronisation drive requestCheck the po...

02 47=Supervision for telephone line communication.monitors the dedicated telephone line medium which is provided for Emergency communicationsThe ded...

PM'D you

Are you able to send me a write up on how to do it?

Did you switch the eeprom to write enable? Menu 1-8-1 Last edited by heisenberg; 08/24/21 01:56 AM.

Have you connected Cadi to it?? To see all node statuses

Maybe try to find where the JNFF input is on the car board, and try different NC or NO connections on it?Also, have you checked your 24vdc is not drop...

Sounds like the board is bad. Pretty common with a power spike. Have you tried China? AliExpress usually have them

Work on the controller that is showing 'M' 2. Bring car to floor where controller is located3. Switch to inspection (JRH) in controller4. Commands >...

You need to program that board to the specific landing.I cant remember the exact procedure but will try to find and get back to you

this is not used for CADI. the rs232 plug is used

com1 port is not used for cadi..

Are they MRL? If so, make sure you have chain block ready to lift the counterweight if your brake power supply bridge rectifier suddenly goes and the ...

For those wondering, it's a MRL...We raised the counterweight with a chain Block attached to brackets above Found the brake power bridge rectifier was...