Elevator Forum

I stand corrected...You can reprogram with an HHT.

If you have another elevator in the building you can copy the PCT and SCT on the GIO360 board and those should work.

The problem arises when contacts from one source become common to other sources in a different supply. Once this happens things get jumped out. So.......

You are not blowing fuses because more than one power feed is grounded. Most system are HOT to ground! This isn't! With multiple grounds in the system...

Sounds like you have 2 sources grounded. With a ground effecting the doorlocks or should I say 79-00 this can be bad! We would use a 200 Watt light bu...

We use Acorn. Not the smoothest unit at rail joints but just gets it done trouble free.

They have long since gone out of business. No support at all. No parts either! They used Cemco door parts with GAL swing door locks!

It was a low power supply on +15v. Miltronics supported the repair on the Drive. I did talk to Unico tech support and both were very helpful!

Are you oiling the stationary segments with #13 oil. I think that's the number? These older guys used a conductive oil to work properly? Hows the LI i...

What type of selector is it? SD selector or the older black board selector with the single chain? What type of relays are used on the control? ES Rela...

We are losing the ready contact from the drive right at the start of acceleration. Only in the down direction....Suspecting the tach is failing at tim...

They are 2 different problems at the same building? We tightened up the DCL and gate switch thinking they may get conflicted at times. That helped! We...

Not sure...I always find it with 44 or 45 error. Faulted out?