Elevator Forum

Kiwi,Nah...didn't loose the job, but just lamenting the fact that not only am I unqualified to break this card open to re-wire the contact portion whe...

yaaaawwwn...the window of opportunity has since passed. so it is in the elevator world. things will continue as they were for a period of time, and ju...

ho hum. didn't think this question would stall for this long. can ANYONE offer a suggestion here?

jericho,I don't know of the specific code to cite it, someone else may up on that, but I did have an inpector write up to replace a traveling cable th...

GreenPants,Not on this subject, but sorta. I have a customer who would like to have installed momentary keyswitches in the place of the terminal hall ...

Dan,Hope the knee surgery went as well as could be expected, and hope you have a quick recovery. If anything pops up 1220 wise we'll get in touch.

HEY DAN!!!He asked,"WHAT BOARDS YER LOOKIN' FOR????". I wanna see this 1220 thread go somwehere!

Hady,Type the passcode in your reply and I'll tell ya how to log in to the Orona.Just kidding. Do you know if the software requires a passcode to log ...

Hey Vic,You mention a few things that have become quite apparent as of late. And they are;1)Poor response from the "company"...2)Pissed off customers....

well there ya go vic...ya scared off another one!

Dan,How would you "add 'extra' spring tension" on that kooky limit roller? Drill a hole on the bottom of the arm and fasten a spring to that point the...

Jim,You have a U.S. roped hydro? Where?

Scott,Mobe B (Special Service Mode) is a pretty much non existant mode with the 1230. You'll find the car, usually a simplex, sitting at any floor, do...

Also with regards to the 1230, barring a valve issue, noise suppression is important too. Check the VM strips on the upper left hand side of the mothe...

Hamed,You've been given some good advice here, not to mention several clues, and there are more, that relate DIRECTLY to your trouble. However, I woul...