Elevator Forum

Be sure there are no gaps AT ALL between the slowdown magnets at the bottom. Check too that those magnets (once confirmed they’re in place) are glued ...

Well heck.Only other thing I can think of is the EPU Link Board on the car top. It too has fuses, one being for communication “from” the car.

There should be a 5v test point (TP5) on the SPU Link Board, you don’t make mention of that in your reply. What color is the SPU button on the upper l...

Have you checked the voltages on the SPU Link Board?

Excel,If you’ve swapped all hall p.b. Boards, and your trouble followed the swap, I would suspect it’s a hoist way board issue.*Do the power LED light...

Zach,What the MCE manual say about uPEnc? It’s gotta be in there.

Half a dozen years ago?Search EPCO Elev Fixtures and maybe you’ll find what you’re looking for. You have part numbers and photos, so a supplier may ha...

Robo- I responded to your new thread on this issue.

“Only at the Lobby”. I’ll assume Lobby is lowest landing. 1) Dead Zone too tight?2)Floor Magnet at Lobby slid down? DS limit opening, and LD input sti...

First off, you’d be smart to get your hands on the job prints (if still available) and copy them, or a comparable duplex set from that era.Yes it can ...

Scarz,Sent you a PM.

The OP reports he’s had a tech out once, but is now experiencing difficulty in getting a follow up response. It appears he’s contacted other area comp...

mjz,You seem a pretty observant person, and those observations most likely declare what the issue is. I don’t believe, although I could be wrong, and ...

Vator,Best bet is to start a new topic thread including what it is you’re working on and any relevant info. The thread you jumped on is four years old...

All from a generator swap? Wow...that’s no stupid controller either.Rocketing into the OH like the pictures show, seems like a catastrophic brake fail...