Elevator Forum

Install a keypad inside the elevator and have it wired and programmed to operate whichever door you desire at any floor. Pretty easy to accomplish. Ch...

I realize this does not really apply to this post, but had a long day on a TAC32. The hall calls quit working, and had wired faults pop up. Door locks...

Knock on wood, this unit ran all weekend! I might have gotten lucky with the parameter changes I made last Wed.

The faults are very intermittent. Every couple of days. Are the adjustable variables for shutting off these faults in the safety processor? I've been ...

No cavitation.

Very tired tonight, sorry for the brain farts, oil temp sensor and low oil sensor are not even wired into the controller.

Forgot to mention, that I've had to reset "hot oil, and low oil" faults several times after it put unit out of service. GAL says it's just a glitch, a...

Yeah, I agree, S&S seems to be more reliable than Siemens. Was told that the Siemens was not really designed for hydro elevator use, have replaced...

By the way again. Just a CMA on my part. Set the governor, without the safety string jumped out first to ensure the governor switch is functioning pro...

Sorry, if anyone read my post, it's connector XC1, NOT XC3 for the safety string, sorry about the typo, glad I read it again. Their are labels on the ...

First of all, don't shut the disconnect off, remove the XM16 connector. Otherwise you may "kill" your hall call boards. Before you start the test, jum...

No, "L"

The IECA power units with twin holeless jacks and serial link Elevator Controls, and Atlantic Tech door operators. They are a disaster! They are built...