Elevator Forum

I'm in the same boat. I need a manual or procedures to set up the amp board and a hoistway scan.

To talk to dmc1. Use the orange cable. Then go to device manager on the laptop and change your communication port from 232 to the 485 port. Then you s...

If you have a G.A.L. MOVFR check the DPM cam and make sure it is fully engaging every time.

Fixed! Problem was bad uc relay base on car A.

Bump

New problem same elevator. This is elevator #7 of 7 and is hooked to a group dispatch. This is what its doing. It will go to bottom open and shut the ...

Found it. It. was a timer added to the controller and not the print the timer went strait to the da relay and would pick da after it faild. Thanks for...

They all 3 drop at the same time then pick right back up.