Elevator Forum

We had a job that the resink wouldn't work unless the pistons came fully down. So we added longer bolts on top so at night when it went to resink the ...

Alimak is an easy company to work with and yes they do say to replace the safeties every 5 years or something on those lines.

Very cool I have gone thru a lot of conduit to go a very short distance with a couple compound bends before!

80% of all call backs are door related! So type of equipment is secondary to number of openings. We do not sell less than a 1 hour maintenance contrac...

So worst cast you go thru an extra packing and just look at it as a cost to do the repair. This would be a billable for anyone unless its the company ...

Hang the car as high as possible then hang the piston with another jack clamp.Make sure you mark the jack so you will know your difference from as hig...

This can get very tricky as to perceived ride quality and noises. We rebuilt a machine twice for a customer that did the same thing and it turned out ...

pieman where do you get this cleaning product and or what is it called?

TRY Miltronics we have had good luck with drives with them.

Ok top floor gong still unhooked with no failures. Looks like that was the culprit. More info when we install the new board.

Admin Not kidding about wanting those boards if you still got em.

could also be spider gears if you have replaced and checked the rest.

We have used a camera to record the controller and play back to the reported failure time. You can hang some tell tale lights on older equipment . A s...