Elevator Forum

Compare the wires on the first floor panel to those on the top floor. Provided the first floor have fire service key switch, the top floor should only...

I have a Wurtec S3 analyser that has 16 channels hooked up to a controller that has all the functions you mentioned.

Replaced "BCX", "BC" all 3 aux. "M" contacts on drive contactor, "PR" relay and the drive contactor. Also replaced the MSU board and miprom power supp...

It happens before the car even gets a chance to move. I first found one of the n/o aux. contacts not making earlier this week. I replaced them and it ...

Thank you all for the great advice and information. I'm not looking at giving up my mechanics card at this point, but just collecting information and ...

Very sad. My prayers go out to his family.

What is the price for the laptops?

Update on this old dog. Prints say 1951 for the year. Type is a 2BC-VCL. After spending all yesterday getting very familiar with the prints and the ci...

I have not put a tach on it and ran it to see if there is any differance in the speed from one direction to the other.

Check brush spring tension and verify that brush spring arms are not bottoming out on brush holder.

I've got a good manual for the Ascension 2000 with all parameters, fault codes and alot of other good information for use with the tool.