Elevator Forum

It sounds like I need a tool or some C4

It is a Miprom SL controller and the only controller prints I have (WD-18184) do not show any I/O descriptions. I just received an adjustment guide fo...

Door goes into nudging (I'm old) fine if the beam is continuously broken. Only stalls when the beam is broken at final close and slowdown areas.

Thanks that's perfect

Unfortunately the Inovation and Adama buttons have an OD of 1.3" + and the holes in my plates are only 1.25"

Old Otis (60's era) basement traction with ESI controller, GAL door equipment and operator, CE digital PI's, unknown cab mfg. All newer equipment inst...

Sorry I didn't post sooner, but I had a really busy end of week. No luck on the button which frankly amazes me. First that the manufacturer whoever it...

ESI controller, discrete wiring. If I cant find these buttons I will have to go to something else, but the holes are only 1.25" and that presents some...

Not Mad, I tried them too??? I have opened all hall stations and the COP and there is no manufacturer info at all. Same with all the job docs I can fi...

Yeah I thought so too, but it doesn't match dimensionally and the mounts are opposite. I called Innovation and they didn't know either. No markings on...

Here is a front and back picture. Attachments IMG_0742.jpg (111.4 KB, 96 downloads) IMG_0743.jpg (106.55 KB, 72 downloads)