Elevator Forum

Very easy to do. Take your 19mm tools with you.

99 is the state, condition, of the system......not the fault. You're getting the first two snowflakes from left to right? The third is doors. Did you ...

Originally Posted by spittman End of line resistor reads. 118.4 ohms. Is that right ? Close enough. 120 by the print. Is board plugged in correctly? ...

Is the machine room at the top or bottom. This will determine the roll call. I have seen in the past where the actual board that is causing the proble...

You can try to blow part of the oil back into the tank but you're still going to have a mess in the pit. You will need to pull the bleeders from the t...

Need to know what drive you have in order to set loadweighing.

You are correct that the display showing 5 in 5-1 that the system is seeing 5% load. That should not be an issue. There are no pots to turn on the v3f...

I have had the YAS board cause this problem.

To do the test properly, you will need the book for acceptance testing of this type of unit. CADI would be great.