Elevator Forum

SCPU On the SCPU the complete configuration is stored in theEEPROM. Because there is no possibility to do anelectronic backup, the whole configuration...

replace SCPU

remove the SCPU and wipe the contacts and insert back into the slot.

reconfigure the LOP,if it doesn't work replace it

without tools like CADI, SPECI it is not possible, unless you can buy modutool on the open market.

3603 E_BIOBUS_NODE_DEADDuring operation the communication to a bus node (e.g.landing operating panel) has failed.Note, this error occursevery time the...

SERIAL PORT

Hello,Cadi gc 3.10 can be useful for all MX GC, TX GC, BIONIC 4,5,7, SC. However, Cadi is not suitable for Smart lifts. For Smart rel. 2, Modutool can...

Hi, try these two possibilities.commands:161 [16/1_/_ _ ] Reset pit inspectionThe activation of this menu resets the pit inspection. Is equivalent to ...

Hi,Status ?

[email protected] just ask

MODUTOOL

Welcome,if you need a new error list, you can contact me

02 63 20 11 DS Applicable for EN81_20 feature: close end signal is missing for 10seconds when doorsare closed with further calls are present.Close end...