Elevator Forum

Thanks for the info. I haven't been back there yet, maybe they haven't experienced it in a while, but I'll check these things.

I ended up replacing it. The drive came programmed from the factory just had to adjust the opening distance with the ssm tool and do a learn. That new...

I haven't reseated the boards yet but I did push on them and pull on all the wires to see if I could find an issues. It probably occurs once every few...

I tried resetting the error every way possible. It still runs in slow speed only and slams in the open. We are going to replace the drive assembly.

It ended up being the 80 and 80a relays were not holding in and the 22 relay coil was bad. It is surprising that it ran most of the time with all thes...

The double re-boot worked! Thanks guys for your help.

I did not do a double re-boot. How is this done and what does it do?