Elevator Forum

Thyssenkrupp- adjus...
 
Notifications
Clear all

Thyssenkrupp- adjust door-open time

9 Posts
5 Users
0 Reactions
14.1 K Views
 MBF
(@mbf)
Active Member
Joined: 17 years ago
Posts: 4
Topic starter   [#24549]
Hi
I have a problem about adjusting door-open time. My problem is that when the car is in landing, the door closes at speed so that it hits the passengers. Therefor I have changed this parameter by diagnostic units I and (VI) (WINDIAG software) but this change doesn't execute or apply on the door and it's still like before without any change.
Can anybody help me with my problem.
Thanks

Last edited by MBF; 08/21/18 05:36 PM.


   
Quote
(@tamperprufe)
Estimable Member
Joined: 17 years ago
Posts: 94
 
if it's just a speed and or timer parameter adjustment then it's an easy fix, maybe someone here has the info to help you however on this forum most people use IMS not WINDIAG.



   
ReplyQuote
(@elmcannic)
Honorable Member
Joined: 17 years ago
Posts: 635
 
Hits passengers? Better take the unit out of service ASAP until you get it fixed.

First; when blocked, does the detector edge work properly?
It sounds like your door closing speeds are culprit not door open time.

If your diagnostic has instructions, look at door adjustments for speed control. Or, the door card may be bad not allowing for values changed.

Also be sure the car door is mechanically sound. Loose bearing connection points can cause the doors
to not respond to control inputs as it should.



   
ReplyQuote
 MBF
(@mbf)
Active Member
Joined: 17 years ago
Posts: 4

   
ReplyQuote
 MBF
(@mbf)
Active Member
Joined: 17 years ago
Posts: 4
Topic starter  
thank you
door closing speed is similar to other elevators.but a way, there are tow door in the elevator and both of them have the problem. So there is not mechanical problem.
where is detector edge?



   
ReplyQuote
 MBF
(@mbf)
Active Member
Joined: 17 years ago
Posts: 4

   
ReplyQuote
 jkh
(@jkh)
Prominent Member
Joined: 17 years ago
Posts: 904
 
MBF,

I’ve never used, nor am I familiar with the software you are using. There are multiple door time parameters that control multiple door functions. How do you know you are even trying to change the correct parameters? Did the software come with a manual?

What is your profession?



   
ReplyQuote
(@tamperprufe)
Estimable Member
Joined: 17 years ago
Posts: 94
 
yes IMS(USA) is a diagnostic tool just like the WINDIAG(European) tool you are using however they are not compatible or interchangeable



   
ReplyQuote
(@huskervator)
Eminent Member
Joined: 17 years ago
Posts: 37

   
ReplyQuote
Share:
Scroll to Top