Elevator Forum

Notifications
Clear all

Tac50 drive read C1

3 Posts
3 Users
0 Reactions
2,741 Views
(@take-the-stairs)
Estimable Member
Joined: 17 years ago
Posts: 120
Topic starter   [#28051]
Svc mechanic replaced drive main board. Afterward the drive reads C1 what does this mean? Not compatible software?



   
Quote
(@wltr00)
Honorable Member
Joined: 17 years ago
Posts: 359

   
ReplyQuote
(@indirtwetrust)
Noble Member
Joined: 17 years ago
Posts: 1759
 
It’s a Tac50-04. That’s the same as a 681 in IMS. Typically those are intermittent faults, usually related to grounding. It should clear with a power cycle but if not, make sure you have P24V to the encoder. Comes from F3 on the IOC. If that’s good, you need to look at the encoder interface card in the motor junction box, it turns 24v to 5v and has a plug connector. After that, take your pick of boards to swap, then the encoder.



   
ReplyQuote
Share:
Scroll to Top