Elevator Forum

Notifications
Clear all

Tac32H

6 Posts
6 Users
0 Reactions
2,616 Views
(@unkindbuffalo)
Trusted Member
Joined: 17 years ago
Posts: 44
Topic starter   [#33608]
I have a problem with the car coming into the floors and it starts to bounce at leveling speed, only in the up direction, it’s a twin post, 3 stage jack, no air in the jacks and filters in the valve are clean, it’s a Bucher valve LRV-1, any suggestions? Thanks



   
Quote
(@eelevator)
Honorable Member
Joined: 17 years ago
Posts: 579
 
Sounds like typical stick slip. I would increase the up leveling speed slightly. If no luck there add some maxglide to the jacks. Your other options are repacking the jack. And worst case if the pistons are too polished and you can't get this to go away they may need resanded so there's a better film of oil between the packing lip and piston surface.



   
ReplyQuote
(@indirtwetrust)
Noble Member
Joined: 17 years ago
Posts: 1759

   
ReplyQuote
 KSNY
(@ksny)
Estimable Member
Joined: 17 years ago
Posts: 148

   
ReplyQuote
(@boomer)
Estimable Member
Joined: 17 years ago
Posts: 117
 
Try pulling the springs off the buffers and doing a jack resync
FJR command. Sometimes the springs keep it from activating the check valves.



   
ReplyQuote
(@immrbeefy)
New Member
Joined: 17 years ago
Posts: 1
 
Anytime I've encountered this it was always a bad packing. Packing usually is rolling which causing the bounce. But agree with all other replies above.



   
ReplyQuote
Share:
Scroll to Top