Elevator Forum

Tac32 HN board issu...
 
Notifications
Clear all

Tac32 HN board issue

4 Posts
3 Users
0 Reactions
2,567 Views
(@martin-cintron)
New Member
Joined: 17 years ago
Posts: 1
Topic starter   [#38309]
Hey everyone I’m looking for some info on programming HN boards on a Tac 32. When I perform a DHNF it show all 4 HN are offline but also shows floor 1 and 4 have a zero where the floor number should be. Has anyone encountered this before ? Tried TECCR , TECC , TECF and still the same. On the Car 2 it’s shows the correct floors and ports. Any help will be great thanks



   
Quote
(@gohana256)
Eminent Member
Joined: 17 years ago
Posts: 29

   
ReplyQuote
(@wltr00)
Honorable Member
Joined: 17 years ago
Posts: 359
 
you can also try TECB. It is used to toggle the Teach direction. Top Down or Bottom Up. Depends on where the HN terminating resistor is placed. If it is in the top HN, you would teach bottom up. IN the bottom HN, you would teach top down. Everytime you enter TECB it toggles the direction.



   
ReplyQuote
(@gohana256)
Eminent Member
Joined: 17 years ago
Posts: 29

   
ReplyQuote
Share:
Scroll to Top