Elevator Forum

Notifications
Clear all

Tac 50 scr drive

8 Posts
3 Users
0 Reactions
4,202 Views
(@upndown-frank)
Eminent Member
Joined: 17 years ago
Posts: 13
Topic starter   [#31873]
I’m having intermittent entrapment / shutdowns loss of comm between cpu and DSP also communication of Dpram losted and card 1 and 2 not matching at right time I’ve checked boards with hyperterminal all good clean boards and backplane board I’m losted



   
Quote
(@unkindbuffalo)
Trusted Member
Joined: 17 years ago
Posts: 44

   
ReplyQuote
(@upndown-frank)
Eminent Member
Joined: 17 years ago
Posts: 13
Topic starter  
Hi unkind Buffalo I did check all four power supplies at boards and backplane but not sure what you mean about ripple



   
ReplyQuote
(@upndown-frank)
Eminent Member
Joined: 17 years ago
Posts: 13
Topic starter  
Originally Posted by UnkindBuffalo
You check the power supplies? Make sure the voltage is right and AC ripple?

Last edited by Upndown frank; 10/08/21 05:07 AM.


   
ReplyQuote
(@unkindbuffalo)
Trusted Member
Joined: 17 years ago
Posts: 44
 
I mean checking the DC voltage to see how much AC ripple is on it, I wouldn’t want to see anymore than .50 mV AC on the DC side, I had an intermittent problem with a T4 because the ac ripple was to high



   
ReplyQuote
(@indirtwetrust)
Noble Member
Joined: 17 years ago
Posts: 1759
 
PS1 is the one to focus on. Measure at the DSP card, adjust to 5.2vdc and check for ripple. Also could be card edge connections. Remove the first 3 boards and clean the edges and sockets, exercise in & out.



   
ReplyQuote
(@upndown-frank)
Eminent Member
Joined: 17 years ago
Posts: 13
Topic starter  
Thanks for the response’s guys I will definitely check ps1 ac ripple on dc side on Monday it ran all day today without a hiccup now if I do see a high ripple should just replace ps1 supply right



   
ReplyQuote
(@unkindbuffalo)
Trusted Member
Joined: 17 years ago
Posts: 44
 
Yeah, replace the power supply, usually high ripple is a cap going bad, also agree with indirtwetrust, pull the cards and clean the contacts on the board up with an eraser, and exercise them back and fourth into the base board



   
ReplyQuote
Share:
Scroll to Top