Elevator Forum

Shindler 330 "a" ne...
 
Notifications
Clear all

Shindler 330 "a" new cio board

6 Posts
6 Users
0 Reactions
7,658 Views
(@scottsr)
Eminent Member
Joined: 17 years ago
Posts: 11
Topic starter   [#4399]
This unit keeps blowing the controller s15 3 amp fuse. When we disconect all of the terminal plugs from the CIO car station board- the fuse holds. Where is the best place to get this board? Do i need any programming tool or is it just a swap? Thanks. Sr.



   
Quote
(@elevatedone)
Estimable Member
Joined: 17 years ago
Posts: 132

   
ReplyQuote
(@wrench)
Eminent Member
Joined: 17 years ago
Posts: 32
 
Yep common problem. No tool needed straight swap just check the software chip and the right version board.

Last edited by Wrench; 08/21/12 02:13 AM.


   
ReplyQuote
(@elevatorfella)
Estimable Member
Joined: 17 years ago
Posts: 102
 
Had a problem with a fuse blowing on the CRIPHNA board. Would not blow when powering up on inspection,flip to auto and fuse would blow. Found a shorted thermal in the motor. Temp. Disconnected thermal, replaced motor eventually.



   
ReplyQuote
 jkh
(@jkh)
Prominent Member
Joined: 17 years ago
Posts: 904
 
Scott
You could try Mike Tuttle @ ECI America or Sean @ World Electronics. Adams is owned by Schindler but I have found their prices to be much higher.



   
ReplyQuote
 mbke
(@mbke)
Trusted Member
Joined: 17 years ago
Posts: 41

   
ReplyQuote
Share:
Scroll to Top