Elevator Forum

Notifications
Clear all

OTIS GEN. 2

6 Posts
4 Users
0 Reactions
8,022 Views
(@chicago)
Estimable Member
Joined: 17 years ago
Posts: 120
Topic starter   [#14670]
Getting SHD 2700 fault, something with brake not picking? What would cause it and possible solution? Thanks.



   
Quote
(@magic-smoke)
Trusted Member
Joined: 17 years ago
Posts: 68
 
Brake switches dropping in flight, LB relay dropping in flight. Drive losing brake input. All can cause this fault.



   
ReplyQuote
(@elmcannic)
Honorable Member
Joined: 17 years ago
Posts: 635
 
Maybe those two stupid batteries in the controller behind the swing panel? Are they more than three years old (if you know)? When those go on the fritz, or even close, you'll have all kinds of weirdness. Check them out next visit. Just my 2 cents.



   
ReplyQuote
(@pieman)
Estimable Member
Joined: 17 years ago
Posts: 103
 
90 percent of the time this is the brakeswitches. you can turn off brakeswitch monitoring in the hidden drive menu to keep you running temp but change the switches ASAP , Unitec will sell you the switches with a write up and its a 10 minute job. i always do this to eliminate this first . the brakeswitches illuminate two leds behind the swing panel in the controller ( where the relays are ,i forget which ones but it shows on drawings ) this should tell you if it is the switches.
good luck



   
ReplyQuote
(@magic-smoke)
Trusted Member
Joined: 17 years ago
Posts: 68

   
ReplyQuote
(@chicago)
Estimable Member
Joined: 17 years ago
Posts: 120

   
ReplyQuote
Share:
Scroll to Top