Elevator Forum

Notifications
Clear all

Otis elevonic 401

12 Posts
3 Users
0 Reactions
10.4 K Views
(@nvdutch)
Active Member
Joined: 17 years ago
Posts: 9
Topic starter   [#4985]
having trouble with elevonic 401.car is stuck at casino level with doors on front and rear open.buzzer is on and position indicators in car and lobby are flashing floor number.



   
Quote
(@elevatedone)
Estimable Member
Joined: 17 years ago
Posts: 132

   
ReplyQuote
(@nvdutch)
Active Member
Joined: 17 years ago
Posts: 9
Topic starter  
As soon as the disconnect is turned on the doors both open and the buzzer kicks on,checked buttons allready



   
ReplyQuote
(@elevatedone)
Estimable Member
Joined: 17 years ago
Posts: 132
 
It's been I long time since I have worked on those.

Do you have prints and do you have access to an OMT?
There are some relays on the front right swing panel that include the door circuit.

Also,a little trick is to pull out the cards and reseat them.



   
ReplyQuote
(@nvdutch)
Active Member
Joined: 17 years ago
Posts: 9
Topic starter  
I have the job prints,i tried cleaning and reseating the cards first and no change,i dont have access to an omt.as soon as I turn the power on two door relays pull in od and something else,5 seconds later ndg pulls in



   
ReplyQuote
 Vic
(@vic)
Honorable Member
Joined: 17 years ago
Posts: 532
 
Did you check all the inputs from the typical re-open devices?
Infrared edges (front+rear)
You say you checked buttons already. So you mean you checked not only for stuck hall and car call buttons, but you also checked front and rear door open buttons, right?

Can you run the car on machine room inspection, or car top inspection? If you can, that would tend to discount drive problems, brake function, safety circuit, door locks, etc. Door close limit ok? What are the limits doing? All in their correct state, given the the car position? Got a PPT? Tape ok?

Last edited by Vic; 10/25/12 09:05 PM.


   
ReplyQuote
(@nvdutch)
Active Member
Joined: 17 years ago
Posts: 9
Topic starter  
Have checked front and rear cops,will run on cartop,dol working,if you turn cop switch off car initializes



   
ReplyQuote
(@nvdutch)
Active Member
Joined: 17 years ago
Posts: 9

   
ReplyQuote
(@elevatedone)
Estimable Member
Joined: 17 years ago
Posts: 132
 
One more question.Do the motors have fans on them? if they do,there is a switch,an airflow switch, that tells the controller rather it's on or not.

Last edited by elevatedone; 10/26/12 03:32 AM.


   
ReplyQuote
(@nvdutch)
Active Member
Joined: 17 years ago
Posts: 9

   
ReplyQuote
(@nvdutch)
Active Member
Joined: 17 years ago
Posts: 9

   
ReplyQuote
(@elevatedone)
Estimable Member
Joined: 17 years ago
Posts: 132

   
ReplyQuote
Share:
Scroll to Top