Notifications
Clear all
Topic starter
13/09/2024 5:01 pm
Hi guys,
We are now looking after an Otis 360 and after entering the shaft and installing a new Dialler, we placed the entry switch tabs back in place on the doors, we have the safety circuit but it won't return to service. Any ideas??
14/09/2024 12:56 am
What does it show on the service tool / OFT?
I am guessing it might be stuck on HAD (Hoistway Access Detection) as a result of you having entered the hoistway without following the expected sequence of opening devices, usin the stop switch, etc.
Topic starter
17/09/2024 6:14 am
Hi TheElevatorGuy,
No the tool just says "No 48v".
Any ideas as we can't even move the lift on inspection.
19/09/2024 4:03 am
Did you try an clear the ram and do a reset? If that didn't work check for your 48volts at the controller. Maybe you guys shorted something during the replacement and didn't notice ?