Elevator Forum

Omron sysmac c20 pr...
 
Notifications
Clear all

Omron sysmac c20 programmable controller.

9 Posts
5 Users
0 Reactions
9,569 Views
(@jluff)
Noble Member
Joined: 17 years ago
Posts: 776
Topic starter   [#20475]
3 stop hydro. Car keeps getting stuck on lower landing only Car will travel to the lower landing and doors will not open. Then it will not leave that floor. Indicator says correct floor Then they open n close randomly and the hall call button will light up with no one pressing it. Sometimes the lower landing hall call will stay lit n keep doors from closing.
My selector magnets and mechanical limit switch seem fine
Any ideas on my problem. ?



   
Quote
(@jluff)
Noble Member
Joined: 17 years ago
Posts: 776

   
ReplyQuote
 Jim
(@jim)
Estimable Member
Joined: 17 years ago
Posts: 87

   
ReplyQuote
(@jluff)
Noble Member
Joined: 17 years ago
Posts: 776

   
ReplyQuote
(@snkrhead)
Estimable Member
Joined: 17 years ago
Posts: 77

   
ReplyQuote
(@solidstate)
Prominent Member
Joined: 17 years ago
Posts: 643

   
ReplyQuote
(@jluff)
Noble Member
Joined: 17 years ago
Posts: 776

   
ReplyQuote
(@jluff)
Noble Member
Joined: 17 years ago
Posts: 776
Topic starter  
Snkrhead
The car does not go to the lower landing on its own. It's when u give it a call to that floor from inside the car that it will land there and doors will not open. Door open button let's you out. Then after a power off reset the car will not leave the lower landing but excepts calls and then the lower landing hall call will light up and open the doors and or keep them open intermittently



   
ReplyQuote
(@kenelev)
Estimable Member
Joined: 17 years ago
Posts: 104
 
check the slowdown limit make sure it is open when elevator stop @ bottom floor.
Check the normal limit make sure it is not open when elevator level on bottom floor.



   
ReplyQuote
Share:
Scroll to Top