Elevator Forum

Old Thompson contro...
 
Notifications
Clear all

Old Thompson controller

5 Posts
5 Users
0 Reactions
7,564 Views
(@elevatorfella)
Estimable Member
Joined: 17 years ago
Posts: 102
Topic starter   [#6027]
Working on a very old Thompson Controller. Elevator goes into leveling, relays C1, C2, C3..... Drop out, unit hits final leveling and the motor stalls out. field voltage drops to 26vdc and resistors turn cherry red. Don't have a print, have checked for mechanical binds, seems ok.....unit seems worse in the down direction, runs a bit faster in up. No generator on this job, DC supplied to disconnect from rectifier in basement of building....very old set up. Unit has run ok for 8 years, that I have had it. Any thoughts?



   
Quote
 jkh
(@jkh)
Prominent Member
Joined: 17 years ago
Posts: 904
 
MCE bought out O Thompson. They may still have prints for your job. Try the following people they may still be there!
Jorge Cruz
Robert Honeyman
Roberto Valaguera

East Coast (718)417-3131



   
ReplyQuote
 E311
(@e311)
Reputable Member
Joined: 17 years ago
Posts: 363

   
ReplyQuote
(@edman)
Eminent Member
Joined: 17 years ago
Posts: 19

   
ReplyQuote
(@take-the-stairs)
Estimable Member
Joined: 17 years ago
Posts: 120
 
Cheak your Capacitor in line with the Resistors. It could be a open Resistor. Is this the one with a couple of solid boards labeled S1-S5 about chest height? you have one with several pot switches on it, one of those is a leveling final speed (I think it is K speed, but dont quote me).Try swapping the board s with the other car, it might ride a little funny, but see if it levels? I don't know what model you have, but that might help. Good luck. I am going to finish my beer now.



   
ReplyQuote
Share:
Scroll to Top