Elevator Forum

Notifications
Clear all

Milky oil

8 Posts
5 Users
0 Reactions
7,011 Views
(@beaupeep)
Honorable Member
Joined: 17 years ago
Posts: 316

   
Quote
(@uppo72)
Honorable Member
Joined: 17 years ago
Posts: 562

   
ReplyQuote
(@danzeitz)
Prominent Member
Joined: 17 years ago
Posts: 672

   
ReplyQuote
(@rac66)
Trusted Member
Joined: 17 years ago
Posts: 68

   
ReplyQuote
(@uppo72)
Honorable Member
Joined: 17 years ago
Posts: 562
 
Dan can I ask what you guys do to get the oil out of the ram? Under orders from the boss, we drain the tub, then land the car and then remove the coupling to let the oil drain out. Do you use air to do this and from where?



   
ReplyQuote
 jkh
(@jkh)
Prominent Member
Joined: 17 years ago
Posts: 904
 
I like to land the car on jack stands,
Disconnect the plunger from the bottom of the car
Open the valve and land the plunger
Disconnect the oil line

Modify a end cap for your oil line
Remove the jack head
Fish a copper tube down to the bottom of you casing
Put your Jack head back on
Start adding air pressure...



   
ReplyQuote
(@uppo72)
Honorable Member
Joined: 17 years ago
Posts: 562
 
Originally Posted By: jkh
I like to land the car on jack stands,
Disconnect the plunger from the bottom of the car
Open the valve and land the plunger
Disconnect the oil line

Modify a end cap for your oil line
Remove the jack head
Fish a copper tube down to the bottom of you casing
Put your Jack head back on
Start adding air pressure...

Thanks JKH. I had an idea like this, but wanted the boards ideas too. Most of the time these days, rams that are set into the floor is yesterdays technology, with side acting rams installed today. This can a little easier to do to, get the oil out of the ram with the oil line near the bottom of the caisson.



   
ReplyQuote
(@danzeitz)
Prominent Member
Joined: 17 years ago
Posts: 672
 
JKH is right on. Only thing we do differently is use plastic hose that is weighted and drop it down from the oil inlet. This keeps you from pulling the head. But on some tight jobs with little room betweem jack and piston you have to pull the head.



   
ReplyQuote
Share:
Scroll to Top