KCM831 KDM Drive Encoder Scaling

Guest · 2016-07-21T00:58:00Z

Does anyone know the correct way to scale the encoders on these? I'm getting 197 and 198 faults and 109 faults, 70 switch. I replaced the motor encoder today thinking the one on the gov. shouldn't cause the 70 position errors since that's all in the drive with the KDM. Faults continue, but I noticed that viewing 4-40 and 4-41 on inspect the motor reads 28 and the gov reads 30. I could get the motor speed to 30 adjusting 6-64 encoder PPR but then gov speed would be 32 and it seemed worse. I can't find anything on what 6-64 should be or any scaling procedures. Any ideas?Thanks

Page 2 / 2 Prev

Technical Questions

Last Post by Anonymous 1 week ago

16 Posts

1 Users

0 Reactions

22.7 K Views

RSS

Indirtwetrust

(@Indirtwetrust)

Joined: 1 second ago

Posts: 0

Topic starter 25/07/2016 10:18 am

Yes they are and it's a 5000 lb car. I oiled them good but it might be worthwhile to put oilers on them like the car. I would still like to know why the encoder speeds are so far off.

ReplyQuote

Page 2 / 2 Prev

13 Forums
7,385 Topics
41 K Posts
2 Online
1 Members

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed