Notifications
Clear all
Topic starter
16/01/2024 6:44 am
Car doesn’t work on Phase 2 FS. Goes into Phase 1. Car just sits at first floor door open and won’t move when trying to run on Phase 2. Works fine in automatic. From 1982. No prints. Appreciate any help.
16/01/2024 7:01 am
theres is a lot of questions in the logic ,
FCC relay is ON when car is on Phase2 ?,
is the original C.O.P ? (Some companies upgrade the COP and never wire the door closing circuit.)
the door close when the 2nd contact in the Car call button is close (car call has a 2 pole sw ,1 is for the call ,2nd is for door close ) ,
there is power on the 2nd contact ?
etc........ is a relay logic is a big logic
Topic starter
16/01/2024 10:06 am
FCC relay is energized, but can’t get FCCX relay to energize. Can jump power to it but even jumping power to it the door still won’t close when pressing the button and trying to move the car on Phase 2.
17/01/2024 5:49 am
DCF is ON when car call is pressed ?
if YES ----- C and CX status is ?
if NO ------- connection 47 is 0v or 120V (ac) ? or ST is ON when car is on Phase 2 or UR is ON ?
Last edited by NOTIME; 01/16/24 09:50 PM.