Elevator Forum

Gen 2 over speed sw...
 
Notifications
Clear all

Gen 2 over speed switch

8 Posts
4 Users
0 Reactions
8,332 Views
(@jluff)
Noble Member
Joined: 17 years ago
Posts: 776
Topic starter   [#25179]
Hello. I got a gen 2 stuck in between floors with gov over speed switch out. I can not reset it. I tried with manual reset on controller and by hand at top of shaft. The tiny black cam wants to pull back away from switch. Please help



   
Quote
(@jluff)
Noble Member
Joined: 17 years ago
Posts: 776

   
ReplyQuote
(@rustyiron)
Eminent Member
Joined: 17 years ago
Posts: 34
 
Before the manual reset button will do anything, you need to enable the reset function using the handheld tool.

However, the actual switch is a little white plastic disk that sits behind the governor sheave.
If you get get to that, you're golden.

Last edited by RustyIron; 11/15/18 03:11 AM.


   
ReplyQuote
(@jluff)
Noble Member
Joined: 17 years ago
Posts: 776

   
ReplyQuote
(@jluff)
Noble Member
Joined: 17 years ago
Posts: 776

   
ReplyQuote
(@rustyiron)
Eminent Member
Joined: 17 years ago
Posts: 34
 
I might be mistaken, but perhaps the spring loaded black actuator and the microswitch have nothing to do with overspeed. It's just a thought.



   
ReplyQuote
(@dripcan)
Estimable Member
Joined: 17 years ago
Posts: 131

   
ReplyQuote
(@rolly)
Honorable Member
Joined: 17 years ago
Posts: 729
 
Your activating an I/O with tool to operate a solenoid. You can also use a jumper energize the coil to reset. Check your wiring diagrams.



   
ReplyQuote
Share:
Scroll to Top