Elevator Forum

Notifications
Clear all

fedral elevator

6 Posts
4 Users
0 Reactions
6,195 Views
(@ubro96)
Estimable Member
Joined: 17 years ago
Posts: 55
Topic starter   [#8636]
does anyone have any experience with fedral elevator lulu lifts we were called in by owner who said the company that installed the lift walked away the plc seems to be in some kind of safe mode it just flashes the output going to the hall buttons and won;t take a direction if anybody had a trouble shooting manual for these or knows where to get one that would be great; the manufacture has not returned my calls for assitance



   
Quote
 jkh
(@jkh)
Prominent Member
Joined: 17 years ago
Posts: 904
 
Try turning both the 110 & 220 disconnects off. Wait 30 seconds and turn it back on. Then call it to the lowest landing and send it to the top. It should be ok after that. We have found that after a power outage the unit locks up. Cycling both disconnects usually does the trick.

You can reach them @

Federal Elevator Co
1(888)785-5438



   
ReplyQuote
(@beaupeep)
Honorable Member
Joined: 17 years ago
Posts: 316
 
Had similar problem years ago. Found an input that was labelled in drawing but no wire going to it. Jumped 24v to it and problem went away. Problem would happen every 6 months or so. Ended up leaving wire in place and never had the issue again.



   
ReplyQuote
(@beaupeep)
Honorable Member
Joined: 17 years ago
Posts: 316

   
ReplyQuote
 jkh
(@jkh)
Prominent Member
Joined: 17 years ago
Posts: 904

   
ReplyQuote
(@matt-o)
Active Member
Joined: 17 years ago
Posts: 6

   
ReplyQuote
Share:
Scroll to Top