Elevator Forum

Dover Composite Ove...
 
Notifications
Clear all

Dover Composite Overshooting Floors

9 Posts
8 Users
0 Reactions
7,990 Views
(@wltr00)
Honorable Member
Joined: 17 years ago
Posts: 359

   
Quote
(@johnny)
Honorable Member
Joined: 17 years ago
Posts: 473
 
How much is it overshooting? both directions?? Stopping sequence ISL, LU or LD, 2LR RTT(not dropping) RE 14 & 15 contactors working (core pin not loose)



   
ReplyQuote
(@jcjphoenix)
Reputable Member
Joined: 17 years ago
Posts: 239
 
I recently had a 7 stop overshooting floors in both directions at all stops but top ,bottom , and 4th floor. I checked everything having to do with compounding and I thought I had checked everything having to do with selector. I checked pie plates, cable, bearings, sensors, etc and everything seemed fine. I finally realized the set screws at the end of the shaft with the pie plates were loose on the opposite end from the drum and the whole shaft had shifted maybe 3/16’s of an inch. Why it didn’t effect floors 1,4,and 6 was kind of misleading



   
ReplyQuote
(@jcjphoenix)
Reputable Member
Joined: 17 years ago
Posts: 239

   
ReplyQuote
 TC7
(@tc7)
Trusted Member
Joined: 17 years ago
Posts: 71

   
ReplyQuote
(@seco2000)
Eminent Member
Joined: 17 years ago
Posts: 27
 
Just a note about Stuthers-Dunn relays ....14 15...armature pins are known to break. Relay appears to work but contacts do not make or break.



   
ReplyQuote
(@whadafack)
Trusted Member
Joined: 17 years ago
Posts: 80

   
ReplyQuote
(@philly)
Reputable Member
Joined: 17 years ago
Posts: 256

   
ReplyQuote
(@boomer)
Estimable Member
Joined: 17 years ago
Posts: 117

   
ReplyQuote
Share:
Scroll to Top