Elevator Forum

DMCI hall call prob...
 
Notifications
Clear all

DMCI hall call problem

6 Posts
3 Users
0 Reactions
5,808 Views
(@kenelev)
Estimable Member
Joined: 17 years ago
Posts: 104
Topic starter   [#29371]
Have a duplex DMCI, problem is hall call keep latching by itself and when either elevator go to those call it will not cancel the call either.
Anybody have problem like that before?
Thanks,
Ken



   
Quote
 Mr.E
(@mr-e)
Active Member
Joined: 17 years ago
Posts: 13
 
If you have recently lost your parameters, I would check to ensure that the car ID’s are correct. I’ve had similar issues on a duplex when the to units are fighting over which one is the master.



   
ReplyQuote
(@kenelev)
Estimable Member
Joined: 17 years ago
Posts: 104
Topic starter  
car ID and master and slave parameter had been check already.
Can I switch master and slave from one car to the other?



   
ReplyQuote
 Mr.E
(@mr-e)
Active Member
Joined: 17 years ago
Posts: 13
 
You should be able to. Though if they are set correctly already, I wouldn’t worry about it. Have you tried turning one off at a time and seeing if the problem is Isolated to one car? Could be a bad CLC on one car, causing the issue for both.



   
ReplyQuote
(@kenelev)
Estimable Member
Joined: 17 years ago
Posts: 104

   
ReplyQuote
(@adrian)
Active Member
Joined: 17 years ago
Posts: 3
 
Log in and make sure your call cycling is turned off. Also check your
CLC - Adjustments- 30 to 34 confirm you have cars identified 1 and 2

Ihave 90 DMC 1 on my route and can help with whatever you need.



   
ReplyQuote
Share:
Scroll to Top