Elevator Forum

Understood. But was referencing that his guy could not run it on car top inspection. Agree about MCC3, don’t think I’ve seen one do that before.

You’re going to need the service tool to diagnose that. There are a few things that a POR reset will clear. Some are drive related, some are motion co...

Well your hall door contacts aren’t made up in that second screen shot

Yeah, we had received a defective 360 board. Put in another new 360 board and everything worked fine. Thank you for the input.

You should be able to. Though if they are set correctly already, I wouldn’t worry about it. Have you tried turning one off at a time and seeing if the...

If you have recently lost your parameters, I would check to ensure that the car ID’s are correct. I’ve had similar issues on a duplex when the to unit...

No movement, no function from the UIT at all. Spoke with an Adams engineer, believes that I probably received a faulty 360 board. New one is already s...

Understood. That is usually the way it works, you don’t get a reply or a call back until you are off site. Lol. Once they get it moving the hoistway s...

Have your guys check the I/O’s at the controller and see if the key switch inputs are changing states when they turn the key switch. Have them make su...

On the motion diagnostic screen, what status is it showing? Safeties, selector....? It will help point in the area to look.

Really appreciate having car top inspection stations with a car top light and outlets too ! Boy how we have gotten spoiled. Lol.

Another good thing to try, is performing a new hoistway scan. Sometimes the pulses get out of sync. ( slight movement of the tape, corrupted ram...)