Notifications
Clear all
Topic starter
18/07/2014 9:44 am
Have a car getting selector error 72 at times. Getting other errors on CLC. Unit will run up about 2' and just slow down then speed back up make a bad landing at the 2nd floor. It is a 2 stop with dual jacks thought it was the sensor, but that didn't pan out? I have replaced the selector board, main and aux. sensor board. Problem still exists, also checked the switch tree.....Thinking of replacing the CLC ? Oh does the same thing in the down direction? Any Ideas? And every 20 or so runs it will make a few normal landings?
Last edited by halfpick; 07/18/14 01:45 AM.
18/07/2014 11:01 pm
Check the directionals limit. Sounds like it could be seeing both in the same state.
19/07/2014 12:28 am
yes maybe stuck in the directional limit switch tree
19/07/2014 6:02 pm
Did you check the back card and the orientation of the two magnets?
Topic starter
19/07/2014 11:20 pm
Well, after talking to several mechanics on the phone. And conversing back and forth! I was losing the FST relay contacts on the relay board. It sure gave me a bunch of crazy errors!
19/07/2014 11:25 pm
Good find, thanks for the update...