Elevator Forum

Hi Johnny,Yes mate, it was a wrong DO coil resistance. Changed to another coil and all sweet now.Thanks mate

Hi TheElevatorGuy,No the tool just says "No 48v".Any ideas as we can't even move the lift on inspection.

@spittman,Did you ever find out what the issue was with this one? I have a similar issue with both car and shaft comms led's off on the map panel and ...

Is it also a thing that the floor boards have to orientatated a certain way to perform a correct roll call?

I know the fault code but what is meant by riser? The LCEFCB boards??If so, they all have a green led and all have power on the plugs.It's not just th...

I have now plugged in hyper terminal with a laptop and I get communication at the map panel but nothing at the floor boards or the LCE CPU.We have now...

I have checked all of the floor boards and all have green leds up.I also have the 5v ok led in the CPU and tested it back to the map panel and I get v...

I have no car or hoistway communication led's on the Map panel but resistance is fine at 120 ohms for the shaft and 150 ohms for the car.I have checke...

Hi Jadam,I wish it was that easy, I can't even begin to look at a shaft learn until I clear the 0213 fault as the lift can't find any floor boards. Al...