Elevator Forum

Garaventa has the traction MRL Lula also

Yes sir, easiest monitor to do out there. CE Electronics

We got it handled thanks.

They are still there...however its the dreaded Private Equity that is causing all of us headaches. They sold out and are now awful.If you need the par...

Thanks. We had tested those capacitors and they were good. Must be a bad connection in that circuit.

Second the setting up a call with them. We did that a couple of weeks ago and they even emailed over the results of the call.

Almost afraid to close this out....However, it does appear we had several bad or poorly built boards from SEES. replaced with the above from VE and no...

Assuming you set the old stack beside the new stack and looked for any issues?All else fails, give Texacone or Gorman a call. (assuming you got it dir...

This is a 87 circa, so the boards have male terminals and are bolt on. The voltage is correct. Will meg out the tformer. Have the boards coming from v...

Even if it was in service mode, it should not run with the hall or car stations in normal mode with doors open. You do have the prints? If you remove ...

What distributor do you use for the Wittur? The Tyler folks are really slow and dont seem to be in need of the business.