Elevator Forum

Replaced with correct board and both cars had to be resync and turned back on in correct order. Hall lights now latch but still problem with car PI no...

I have 3 hall boards in MR it's a duplex with single riser should I replace resistor on all of them?

Hall board LD latch light is lit on Hall interface board is the touch tone board on the HIB or the main COP board?

Just the on board display no plug in

Don't have hyper terminal software

2401

Got prints and found NO contact bad not allowing HS to drop out which I would never pick leveling coilsBecause of NC contact on HS would not close in ...

ThanKS in dirt I think that might be a print in there I will see this Monday I will post later that day and hopefully will report what the problem was...

I'm going back Monday I will keep you posted. Now that you said that with doors now I'm thinking it might have pre-opening doors. Hmm maybe?

So when it passes intermediate floor zone magnets hs and hsx drop and SD and sdx pick and drop out at both intermediate floors in down direction but i...

The calls do latch and will not cancel calls so if I select 1c call which is the 3rd fl. From bottom and another fl. Above so car would run up and go ...

Do you have a thermal overload?