Elevator Forum

IF you get a 40 status, theres a big procedure to reload the BOD file. I wouldn’t go that far just yet. What does the display show? Do it run on inspe...

That’s the CANCNA board Jcmowrey, as for the 2138 fault, bad landing unit sensor. Either you broke one off or it took a crap on you. Easy way to check...

Do you get a status 40 when it finally boots up? If you have a fault on software 3.24. Or earlier and reset, you will drop your BOD file.

I've had to change the ethernet cables also.

I'm pretty good with these. Send me your info and I can give you a hand

Careful swapping the board. They’re shipping these out with test software on them.

I get them all the time. I’ve found it’s one of two problems. Dirty interlock contacts or the hoistway door isn’t closing all the time. Check your spi...

They just redesigned the hall pb board also. New style is on its way out