Elevator Forum

Sounds to me you have a bad power supply

GAL has 2 sizes for the cam nylons. Make sure you have both sizes before you take the assembly apart

I would recommend a laptop with the IMS program. It makes troubleshooting a lot easier

Yes... on a HW... Pain in the ass. Watch out for the spring tension

Janus has a toll free number to call that will ask for the phone info, number to call,and message if any then calls back the phone and automatically p...

Check the communication cable going to the drive. There was a TSB which required a new improved one from Kone Spares.

How about the virtual limits? Relearn after floor are entered or enter distances and speeds?

I've been to Moline Ill. several times for training and never heard of a lock out. Maybe outside the US they have something like that but not here.

I would be very careful adding weights to the top of this equipment. It is pure garbage and cheaply made. anytime I need to be on the car top I move a...

Did you adjust the load weigher to "0" with the car on the top floor. They are very sensitive. I usually check and readjust all of mine every 6 months

I think the pin on the crosshead your referring to is where you would engage the bracket on the rail when working on the brakes in case of unintended ...

You can disable the doors and put the controller on auto run. Are you getting any motion or drive faults logged?

Are they the micro switch type? If so change it. They often "click" but if you check it with a meter there is no continuity across the contacts inside...

I know Kone spares has them for sale but I think they are pricey. I can look around and see if anyone has an extra one for sale in the area. Might be ...

On the top of the tool next to the on-off switch is where you plug in 12vdc. The Kone tool will also work on Ecco 3000 and Ecco 5000 escalators. You c...