Elevator Forum

Could you share some picture of the adaptor?

For shaft setup in KONE LCE you should put the car in button floor that 61U,30,77N is lighted in Inspection mode, then put 5-2-1 and NormalFor rollbac...

Firstly try to do the Shaft Setup by 5-2-1Then try the LON download by 5-7-1And clear the error with E-2-1Power Down and ON

Or magnets.

Also, might be the travel cable issue, you can swap the wire that carry it signal for check.

If it happens when car is in certain floor, could be travel cable problem.

That shouldn't take such a time unless one or more component has issue.Starting from CCBN is a good idea.Also, remember you can change NVRam of CPU wi...

I am confused, what is the question?

Good Morning,When you not familiar with any controller could be misty for you.I work with KONE LCE most of my carrier and happy to help.PM me if you w...

What is the CPU version?If it just shows you menu 5 and 7 it is locked.You need a UIO or KNX (depends on CPU version) to unlock the parameters.

First question is the car moving in RDF mode? (up and down from control panel)Because Wight issue s for Normal ride (rated speed in car call)PM me if ...

Also, don't forget that you have to save Drive Parameter before reset.change 6-99 to 1 for save.

in meanwhile check the motor cable termination at both end.

Do you have any manual or fault code for this KONE KCE type?