Elevator Forum

It is wired into the EE circuit and should close as there is not phase 1

Are you getting any faults and you probably don't have door communication do you.

This happens at both terminal floors. DOL goes high at these floors. After it sits at a terminal landing it will close on DCP.

The elevator doesn't go to the lowest landing automatically and park. When it is called/sent to the lowest landing the doors remain open until a car c...

Another problem showed up today, on automatic when the elevator goes to the lowest landing the doors stay opened until a car call is entered. Works fi...

We cleared the ram and works fine now. Thanks for the help.

It will go to the 7th landing on phase 2. We can see the I/o change for the 7th landing on the service tool when the 7th car call is pushed. All card ...

We will clear the PF Ram tomorrow, no faults on OCSS and the RCB was just repaired by unitec. When the 7th floor car call is pressed we can see the 7t...

Are you referring to the ring car board

The button modules are universal going into a car module which is then decoded to tell what level has been pressed which we swapped to another level a...

I have checked the security input for the 7th floor and it is fine. The problem I am having is the car will run to all other floors but the 7th landin...

2908 DBP input errorThanks