Elevator Forum

Like other people also mentioned there are many reasons why you should not consider Smartrise. Firstly, all their engineering and support has been mov...

I was hoping I could hear more about your experience with smartrise warranty issue rather than alpha controller, MCE, EC or other companies. Please do...

Ellies is an award given by Elevator World magazine. Like EElevator mentioned "it's a feather in the hat of the CEOs to be able to point to"I remember...

I totally agree with EElevator. Don't make the mistake of installing Smartrise just for less wiring. It would cost you the following:1- Terrible techn...

I totally agree with EElevator, the combo that he suggests is what I would go with, and is probably the most reliable.I would never ever recommend Sma...

LRM is the "Lock Rear Middle" input which is the input for all mid-floor locks of the rear door. Those high-voltage inputs tend to fail a lot and you ...

Make sure LON-Bus cable is properly grounded only in the machine room side. Also check the termination resistor at the end of the bus.

Yep, those two relays fail all the time! You can see spark inside them when the contactors pick or releases. Definitely a design issue. No need to men...

I give it to everyone who need it for free. Just PM me

Merry Christmas !

I would certainly recommend GAL. I have worked with both of them and found GAL more reliable than Smartrise controllers. My feeling about Smartrise co...

Were you able to figure out the issue?I know they have an interface board between the landing system and controller which is supposed to save the loca...

Is this the old (V2) or the new C4 hydraulic controller?