Elevator Forum

E-mail sent

PM me a e-mail

In general, there is no specific place to locate the machine room. But it is most logical to place it as close to the jack as possible. Reasons? If th...

Put a sleeve on piston. Floor to floor length of 5 to 6. May change your pressures. When building decides to change their mind on it, then just remove...

Check nA1/nA2 and nR relays sometimes a back contact is bad and doesn't cancel calls.

Replaced LCECOB got car LON. john jay: early version of Mipron HS. Yes they do run great. By the way when the CPCB was replaced, one of the solid stat...

Other than the battery ?

MC1_AUX-MCDDRV feedback from MC1 not matching with MCPDRV command.Error Type: Open_Flt_Clr_prop_OpDefective aux contact on the motor contactor.Defecti...

$ SSM. Only have 1 unit but I've heard of a few drives going bad

Any one have info on these, duplex, 5 stop, DC Hollister, magnatech drive.

I'm with Boa, Kone has been going around fixing them all over. I believe it was a lawsuit. Also the lower carriage likes to get hung up, not putting t...

More cranes = more work, more work = more people. You just gotta love the cranes.

1965