Elevator Forum

the Spectron was the 1st AC Drive and proceeded the Digital SWEO Drive, unfortunately very few were installed. Parts may be a problem.

There was a keypad display that showed fault codes and such on the Baldor Units. Is it on site? It also was how you changed parameter values.

You must have a Baldor or some other type Drive. The SWEO Drive was integrated into the Tool Software. The Baldor and some of the Baldor replacement D...

I only ever used a company service tool. The world tool should have a drive adjust screen. Unless you need different software for an AC Drive.

Just another thought, it may be that your Vane Readers have moved. 1/4 or 1/2 inch is a big deal.If you put the car at the floor on Inspection from th...

Does motion averages say your up and down speeds are the same. if not you can adjust them through Drive adjust, ADC 1 offset I believe is the paramete...

Go to MSU adjust, Motion Info, 3rd screen back,velocity information. This screen lets you compare the velocity command, the position encoder, and the ...

Usually when both LED'S are high on the power supply board that indicates that the Power Supply Board is bad. I would start there. With all the I/O an...

A post script to my previous post. If you dropped everything when you clipped the lock and slid into the overhead from there, and the Brake is in prop...

Good find, but the terminal slowdown switches should be looked at. They should have slowed you down in that situation. They may need to be tweaked.

the load weighing may need to be setup.

what was the numbers that the Inspector cited in the A17.1 Code.

Gator, I have been involved in many High speed Mods. You are correct in worrying about the Landing system. Tape systems will not work. I was lucky in ...

First of all Ohio does not have a license for Elevator Mechanics. That tells me you may be using Licensed Electricians to do the work. However if that...

when the Genny is idle and with no demand, what voltage are you measuring across two adjacent Brushes. It should be like a volt or so. you may be buil...