Elevator Forum

That buzzer you hear may not be fire recall. I had problem with switch tree on top of car and heard that buzzer also . Those marsh Mello rollers are p...

What’s your email

Zap supply

No cable

Yes I have one brand new in the box

Car working great after replacing valve body. I don’t know what happened to the original .. as far as I knew it was working fine before motor went bad

The valve body is just by passing with out building pressure. I turned relief in all the way basically. Doesn’t change

So I exhausted all testing. I have 135v to coils. Up slow and up fast. They get energized but the pressure never builds past 180 psi. I need 240 psi f...

I didn’t change the pump. Just the motor. I hope the pumpIs ok. I read if the pump spins you don’t need to replace it with the motor

Even when I shut off valve going to shaftway it doesn’t build pressure. Stays around 170psi Is it possible the valve body was the original problem tha...

I got the car off buffers and level on first attempt after turning up slow all the way in then out 2 turns. At that point my car was in recycling mode...

My static pressure seems to be around 120psi. When motor pumps I can get it to about 170ish psi . 180 psi is my empty car working pressure The motor s...

How can I tell if motor is running in correct direction ? Only way drive comes on is jumping 108-115 on con 10. up direction comes in drive says motor...

Car is in pit probably on buffers. My up slow coil is energized. Ims says up is in . The first thing I did was turn up slow in .. after a full turn in...