Elevator Forum

I think I found the issue, to do with the leveling magnets not being setup correctly. The lift would occasionally return to the bottom floor and open/...

Did you replace the relay holders as well?

To reset ucm faultHit enterNumber 10 will appearHit enter again, it will change to 101Hit Up and get to 127, hit enter127 0 will appearHit Up to chang...

Might sound silly but did you trip the safety gear switch?

Figured it out, it's the CSB belt pulse sensor monitoring device... It had detected a bad belt and caused the fault!

1) Ebrake failed to pick.2) Ebrake/Rope gripper switch failed. LED D182 failed to light and/or D181 failed to turn off.Terminal XEB2/7 remains at 20vd...

Try contacting O'Keefe Elevator company in Omaha, they took over Kimball Bros elevator company. They may have an idea on how to repair or replace that...

3rd party non proprietary all the way, it doesn't matter if a Schindler will run 'fine' for a while with limited 'bugs'. Eventually, down the line, it...

B (hex)/11 (dec): DRH-D button on the recall panel is pressed without active recall control JRH; check wiring of JRH / DRH-DIt seems that your inspect...

Anyone know where I can get miniconsole phone app from?

Would also like some info on these please