Elevator Forum

rope lube took care of it.

I have seen and faught this same scenario. See if your cartop inductor wires are shielded. If they arent then splice a shielded set of wires to the or...

Already had replaced battery at thqt point. Like I mentioned...it turned out to be the selector brd. Replaced it and ran setup and has been going stro...

Yep. Done all of that. We did test for and find rope slippage of about 9" and will try a little rope lube to swell the ropes. Also will check balanced...

The selector brd. Sorry.

Service tool was screwy. Replaced the tape reader and set up manually then got another service tool to verify parameters. Thanks for the help everyone...

Some ideas you may want to look into. In the drive there is an EEPROM chip...I think it's the U15 chip, that checks and validates programmed data afte...

Sorry...autocorrect got me. Replace the word "cover" with "clc" as in clc board.