Elevator Forum

Interesting question IDWT,I PM’d this guy asking for answers to my questions (to not bore the forum) and didnt get the response i would expect.You mig...

Issa,More information please...Suggestions were provided to your original post. Which have you tested, and do you have the MCE manual for this job?Whe...

Issa,Welcome to the forum.If the car seems to run on automatic, leveling properly etc., look for the DOF input to turn ON using the CRT screen if ther...

Typical TSL limit switch description. The break in the wire may even be in the unistrut OR just bad contacts on the limit switch itself. Be sure to ch...

Certainly does sound like the pulse count has been lost. Once learned, and after it craps out, is the pulse count still present? Sounds like it happen...

elevatorguy-Thanks for posting the fix.

Thanks John for the detail. Hopefully TKEBob can use your information.

Not sure about being on inspection, but could the same be achieved on auto with the doors disconnected? Shouldn’t take much.

Those IBM relays are a punk when you suspect contact troubles. Pulling them out, visually looking through the relay body for debris across NO/NC conta...

“Yes the brake picks like it has a demand”. That’s your clue.Will the directional stop it on hall access?And as Johnny asked, what happens if you send...

For the OP-If it is a cold start, adjustments for slowdowns, Fire Recall main/alternate, viscosity and Fire code applicable to your state etc will hav...

Well Pie,ESB normally refers to Emergency Stop Button. Check those switches starting in the controller for safety chain stop switch. Look around on yo...

Hey Dirt,What is it...In the manual, you have to set valid door openings, and valid floors right? Two different charts. Single car etc. I suspect an e...

Sean,Google Motion Control Fault PPS and it’ll direct you to the MCE site, first hit it the entire big book.Scroll down to Table 6.10 and it’ll start ...

HiI have a problem with xxxx and i desperately need help from you forum folks. I’ve trie everything and I’m stumped. Please give me all the informatio...